New LED behavior (active-low, PC15=LED1, PC14=LED2):
Disarmed, IMU OK : LED1 solid ON + LED2 off
Armed : LED1 solid ON + LED2 solid ON
Tilt fault : LED1 blink 1Hz + LED2 blink 1Hz
IMU error : LED1 blink 1Hz + LED2 solid ON
Rule: solid = good, slow blink (~1Hz) = needs attention.
Removed the confusing fast-blink-at-5Hz-for-error and the
baro-flash-every-5s patterns.
status_update() signature changed: baro_ok → armed + tilt_fault
so the LED pattern can reflect arm state directly.
Closes#22.
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
On boot, before the main loop, sample 1000 gyro readings (~1s) while
board is held still. Compute per-axis mean offset (sensor-frame raw LSBs)
and subtract from all subsequent readings in mpu6000_read().
- mpu6000_calibrate(): LED1+LED2 solid ON during 1s sample window,
resets filter state to zero once bias is known
- mpu6000_is_calibrated(): gate; main loop blocks arming and USB
streaming until calibration completes
- Bias subtracted in sensor frame before CW270 axis transform + scale,
so all three axes (pitch/roll/yaw rate) benefit
- config.h: GYRO_CAL_SAMPLES=1000
- No flash storage — recalibrate fresh each boot (bias varies with temp)
Closes#21 (3.5°/s yaw drift), #23 (gyro bias calibration on boot).
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
