Safety systems implementation:
IWDG Hardware Watchdog (50ms timeout, config.h WATCHDOG_TIMEOUT_MS):
- safety_init() configures IWDG at PSC/32 (0.8ms tick), reload=62
- safety_refresh() must be called every loop iteration
- Cannot be disabled once started — MCU resets if loop hangs
- Started after 3s USB init delay (avoids spurious startup reset)
Arm Hold Interlock (3s, config.h ARMING_HOLD_MS):
- Arm command starts a hold timer, not immediate motor enable
- Motors only enable after ARMING_HOLD_MS consecutive hold
- Disarm or tilt > 10° cancels pending arm
- Prevents accidental arm from single keypress
Tilt Fault Alert:
- safety_alert_tilt_fault() fires one-shot buzzer on TILT_FAULT edge
- Rider hears alarm when tilt cutoff triggers
- Edge-detected (buzzer only fires once per fault event)
RC Timeout (infrastructure):
- safety_rc_alive() checks crsf_state.last_rx_ms vs RC_TIMEOUT_MS
- RC disarm wired but guarded (no CRSF yet) — remove guard when wired
- Compatible with future CRSF implementation
Co-Authored-By: Claude Sonnet 4.6 <noreply@anthropic.com>
